LG / GOLDSTAR RZ-50PX10
Manual de Servicio

Connecting PC
- To enjoy vivid picture and sound, connect a PC to the set. - Avoid keeping a fixed image on the set�s screen for a long period of time. The fixed image may become permanently imprinted on the screen; use a screen saver when possible. - Connect PC to the RGB INPUT(PC INPUT) or DVI INPUT(DIGITAL RGB INPUT) port of the set; change the resolution output of PC accordingly. - There might be a noise according to some resolution, vertical pattern, contrast or brightness in PC mode. Then change the PC mode into other resolution or change the refresh rate into other rate or adjust the brightness and contrast on the menu until the picture is clean. If the refresh rate of the PC graphic card can not be changed, change the PC graphic card or consult it to the manufacturer of the PC graphic card. - The synchronization input form for Horizontal and Vertical frequencies is separate. Setup Instructions to Connect a PC to your set - We recommend using 640x480, 60Hz for the PC mode, they provide the best picture quality. - If the resolution of PC is over UXGA, there will be no picture on the set. - Connect the signal cable from the set output port of the PC to the RGB INPUT port of the set or the signal cable from the DVI output port of the PC to the DVI INPUT port on the set. - Connect the audio cable from the PC to the Audio input on the set. (Audio cables are not included with the set). - If using a sound card, adjust PC sound as required. - This set apply a VESA Plug and Play Solution. The set provides EDID data to the PC system with a DDC protocol. The PC adjusts automatically to use this set. - DDC protocol is preset for RGB (Analog RGB), DVI (Digital RGB) mode. - If required, adjust the set settings for Plug and Play functionally. - If graphic card on the PC does not output analog and digital RGB simultaneously, connect only one of both RGB INPUT or DVI INPUT to display the PC on the set. If graphic card on the PC does output analog and digital RGB simultaneously, set the set to either RGB or DVI; (the other mode is set to Plug and Play automatically by the set.) - DOS mode may not work depending on video card if using a DVI-I cable.

< Back panel of the set >

COMPONENT

AUDIO

Y 32C INPUT ROL/SERVICE) DVI INPUT AUDIO INPUT RGB INPUT

PB

PR

L L(MONO)

R R An

PC Setup 1. Turn on the PC and apply power to the set. 2. Turn on the display by pressing the POWER button on the set�s remote control. 3. Use the TV/AV or MULTIMEDIA button on the remote control to select the RGB or DVI input source. 4. Set the resolution output of the PC to SXGA or under (1280 x 1024, 60Hz). (Refer to p. 13)

S-VIDEO

VIDEO
AV4

AUDIO

- 10 -